If you have any question you can ask below or enter what you are looking for!
Press the Menu button on your remote. Select Settings & Support. Choose Preferences. Select Guide Settings.
Highlight the « Remote » selection and press « OK. » Choose the « Program Remote » option and follow the on-screen instructions to program your remote to work with your TV set. When finished, the volume up/down buttons on the remote will work to control your TV’s volume.
Remote control won’t change TV channels Make sure there are no obstacles between the remote and your TV. Move closer to the TV and make sure the remote is pointed directly at the TV’s front panel. Make sure the batteries are installed correctly. Try fresh batteries.
Solution 5: Resetting Spectrum Remote to Factory Defaults Press and hold the TV button. While you are still holding it, press the OK button for 1 second and then release both buttons at the same time. … Now you have to press and hold the Delete button for 3 seconds. . . . Read more
Remote Not Changing Channel/Slow Response Press the CBL/Cable button on your remote, then use the CH +/- button or enter the channel number to change the channel through the Spectrum Receiver. … Verify that the receiver is working properly by using the front panel buttons of the receiver to try . . . Read more
You can configure the parental lock settings for broadcasts and streaming channels on Android TV™ models released in 2017 or after in the United States or Canada. … Select Watching TV ? Parental controls ? Parental lock (Broadcast or Streaming channels) ? PIN Code.
Here is an example of likely steps: Turn on your TV or another device you wish to control. Press and release the DEVICE button on your remote associated with the product you want to control (TV, etc.). … Press the Device Button again, as well as the POWER button at . . . Read more
Check the User’s Manual of your remote control to locate the code section. The list of codes for the remotes on the manual differs. Some of the codes are on the manual, while some are written on a piece of paper that comes with the manual. Locate the code and . . . Read more
Have firestick open on your TV, go to settings-> Display & Sounds -> HDMI CEC Device Control. Switch this off and the 4 digit code will appear. Once firestick is synced to the app you can switch the setting back to On.
Look at the viewfinder or screen of your camera/camcorder or mobile phone. If the remote control sends a signal, you should see a light in the viewfinder or screen of your camera/camcorder or mobile phone when you press a button on the remote control.
